About this deal
This coffin-shaped set of shelves provides a great design focal point for any room and is useful for displaying a variety of ornaments, crystals and figurines. Its very cute and perfect for small areas its standing on top of a kallex unit so I haven't put holes in my wall . I went over the whole coffin shelf with 120 grit sandpaper to get rid of any splinter and sharp edges. If your looking to make a fun DIY Halloween prop or want to make an easy home decor project fit for a gothic bedroom Elvira would love then you have to check this out. Remember to pre drill and apply penty of wood glue and then start installing each shelf into its place.
It's quite expensive for what it is but as its a novelty shelving unit i was prepared to pay it especially as it came ready built .fence pickets to make it easy) We also measured our shoulder level to come up from the bottom 53" high. The ratings/reviews displayed here may not be representative of every listing on this page, or of every review for these listings. Please note that we try our hardest to reproduce the colours of the products with the photographs on our page.
After we nailed in 5 finish nails at each joint of the sides we flipped over the shelf unit to hammer some nails through the back to go into each shelf for added strength.Once you have your lines you can either clamp them on the edge of a table or screw them into place to keep them from moving while cutting with the circular saw. If you have purchased two anklets and they are too big, you can entwine them by adding one to the anklet, then weaving the other (under and over) and fasten as that will keep them both on. If the anklet is slightly tight, you can tighten the little knots by pulling gently but don’ t hold by clasps when doing so as they will snap.